11
OPERATOR’S MANUAL
TRAILED ROTARY TEDDER
P10-1200
Fig. 5.
Places of tedding the tedder, location of centre of gravity
4.5.
Working parts
❑
Before
operating the tedder check rotors’ and tines’ condition.
❑
Worn or damaged tines should be immediately replaced with new ones.
WARNING!
During replacement of working parts, it should be used personal protective
gloves
.
4.6.
PTO shaft
❑
Before operating learn provisions found in bar manufacturer's manual placed on the bar
.
❑
Use only PTO shafts recommended by t
edder’s manufacturer.
❑
In order to operate safely use only fully technically fit, undamaged PTO shafts. Damaged PTO shaft
shall be repaired or replaced with new one
.
❑
Before any operation make sure whether PTO rpm have proper rotational direction.
4.7.
Hydraulic assembly
❑
Caution! Hydraulic assembly is under pressure! Hydraulic oil under pressure may permeate through
skin and cause serious injury, therefore skin and eyes should be protected in particular. In case of
injuries caused by a liquid under pressure, call a doctor immediately.
❑
Hydraulic hoses can be connected to tractor's hydraulics, provided that both the tractor’s an
d the
tedder's hydraulic assemblies are not under pressure. To remove the pressure from the hoses just
simply restart the tractor's hydraulic valves several times, once the tractor is off.
❑
When dismounting the machine from the tractor, set the equipment aside, deflate the pressure from
hydraulics and turn tractor's engine off.
❑
When controlling for hydraulic assembly's malfunction and looking for oil leaks, it is forbidden to
touch any potential leaks until the entire assembly is under pressure.
❑
Note! It is recommended that the hydraulic oil used should not exceed 10 oil purity class in
accordance with NAS 1638.
