16
P10-1200
TRAILED ROTARY TEDDER
OPERATOR’S MANUAL
5.
USE OF TEDDER
5.1.
Attaching the tedder to the tractor
Couple the tedder with the tractor using the three-point linkage bar (
1
) (
) and the bar pin (
2
), which
must be secured with the cotter pin. Then connect the four hydraulic hoses to the two hydraulic pairs
(
3
) of the tractor. Two double-acting sections are required. Connect the drive shaft (
4
) to the tractor's
PTO.
Fig. 7.
Connecting the tedder to the tractor
5.2.
Tedder hydraulics control
After connecting the hydraulic system and the power plug, transfer the control panel and the cable to
the tractor cab and connect the plug to the 12V cigarette lighter socket (
A
)
–
WARNING!
Before connecting the tedder, check whether the polarity of the aggregated
machine is the same as that of the controller (
). Incorrect polarity will
damage the controller.
Fig. 8.
Controller plug polarity
After connecting the controller, turn on the power supply (
B1
) of the controller that will
activate the power supply for the rotation sensors of the controlled wheels. The sensors prevent the
tedder from folding its arms in the event of incorrect adjustment of the controlled wheels.
+
4
3
1
2
