Operator’s manual
Rotary tedder
P4-420
,
P4-471
and
P4-531
Rotary tedder
P6-651
and
P6-771
Rotary tedder
P8-790
and
P8-890
- 12 -
Fig. 8.
Location of center of gravity
Tab. 3.
Location of center of gravity
Dimension
[mm]
Type
P4-420
P4-471
P4-531
P6-651
P6-771
P8-790
P8-890
X
2' 12"
3' 4"
3' 5"
4' 7"
4' 7"
4' 3"
4' 11"
Y
3' 4"
2' 7"
2' 6"
2' 4"
2' 3"
2' 2"
2' 3"
4.5.
Working parts
Before operating the tedder check rotors’ and tines’ condition.
Worn or damaged tines should be immediately replaced with new ones.
WARNING!
During replacement of working parts, it should be used personal protective
gloves
.
4.6.
PTO shaft
Before operating, read bar manufacturer's manual placed on the bar. Follow all safety
precautions in that manual.
Use only PTO shafts recommended by tedder’s manufacturer with guards in good condition.
In order to operate safely, use only undamaged PTO shafts and shields. Damaged PTO shafts
and shields must be repaired or replaced with new ones before use.
Before any operation make sure whether PTO rpm have proper rotational direction.
4.7.
Hydraulic assembly
Hydraulic assembly is under high pressure. Hydraulic oil under pressure may penetrate skin
and cause serious injury or death. Skin and eyes should be protected when working around this
assembly.
