Operator’s manual
Rotary tedder
P4-420
,
P4-471
and
P4-531
Rotary tedder
P6-651
and
P6-771
Rotary tedder
P8-790
and
P8-890
- 29 -
WARNING!
It is forbidden to lower the tedder tines below 0.4'' (1 cm) from the ground as
this may cause damages to the machine such as bending the arms, breaking the
linkage or the gear, faster wearing of the tines, damaging the turf and causing
contamination to the collected forage, etc.
5.8.1. Tedding on left and right side
There is a possibility to adjust the tedder in a way, that the forage can be thrown on the left or
right side. This solution is very favorable when operating on meadow’s ends. Thanks to that
the swath is thrown from end parts of the meadow towards the middle (
Fig. 25
).
Fig. 25.
Tedding to a) the left or b) to the right on meadow edges
It is possible thanks to proper adjustment of wheels. The regulation is done by lever
R,
which
after being put into proper hole adjusts the wheels. If the pin is put in the left hole (
Fig. 26a
) then
the tedder will be directed to left side (
Fig. 25a
), but if the pin is put in the right hole (
Fig. 26b
)
tedder will be directed to right side (
Fig. 25b
).
Fig. 26.
Adjusting the tedder driving wheels – a) in the left opening b) in the right opening
If the lever
R
is not put in any hole then the wheels will be operating smoothly (
Fig. 27a
).
Standard adjustment of the wheel is show in
Fig. 27b
.
R
L
b)
R
L
a)
a
b
