Operator’s manual
Rotary tedder
P4-420
,
P4-471
and
P4-531
Rotary tedder
P6-651
and
P6-771
Rotary tedder
P8-790
and
P8-890
- 38 -
9.
DISASSEMBLY AND WITHDRAWAL FROM USE
9.1.
Repair
Before starting any repair or service the tedder should be cleaned and any grass or dirt
removed. Carefully check nuts and bolts for correct tension and the pins for wear. Replace if
necessary.
WARNING!
Before repair the tedder should be disconnected from the tractor.
The following operations are to be made once the machine is repaired:
make sure that all elements are installed properly,
install the dismounted guards,
check whether screws and nuts are tightened,
once all the guards are installed, perform a warm-up start in order to make sure the repaired
machine operates properly.
9.2.
Disassembly and scrapping
If the tedder cannot be repaired anymore, it should be withdrawn from use
.
For this purpose oil from intersecting axis gears should be drained and delivered to a proper
waste treatment company. Clean the tedder parts, dismantle and dispose properly of all plastic parts.
After that, the tedder could be sold to breaker’s yard.
WARNING!
When unhitching the machine pay particular attention to additional threat such
as crushing, cutting, wounding, concussion and abrasion. Special protective
equipment must be used: gloves, protective clothing, glasses etc. Pay attention
not to allow the machine lose its stability and therefore protect it with
supports.
10.
WARRANTY CARD
ROTARY TEDDER
The product quality has been checked and meets the required standards and regulations and is
permitted for use.
NOTE:
A warranty card without the required information or with corrected or illegible
information –
is invalid.
Serial number
Date of manufacture
Manufacturer’s stamp
QC signature
Date of purchase
Dealer’s stamp
Dealer’s signature
