Operator's Manual
Round bale wrapper
Spin S, Spin F
- 30 -
1 – Machine main frame
2 – Bale positioning arm
3 – Support frame
4 – M16x60 bolt
5 – M16 nut
6 – Clamp
7 – M12 nut
8 – Locking pin
Fig. 32. The bale vertical positioning
Install the bale vertical positioning system on the back end of the wrapping machine in the
appropriate position on the main frame marked on the diagrams as (1) (Fig. 32).
The suport frame (3) shall be mounted to the wrapping machine using clamps with nuts (6),
(7) and bolts with nuts (4) and (5).
Before commencing work, it is required to:
Remove the locking pin (8),
The bale positionong arm (2) will freely drop without touching the ground,
Set the direction of the bale positioning as indicated by the arrows on the Fig. 32.
After the worki s complete, lock the bale positioning arm using the safety pin (8).
8.6.
Drive chain adjustment
Two chain transmissions are used in this bale wrapping machine. After wrapping the first 10
bales, the tensioning of the drive chains needs to be adjustmed. To do this, follow these steps:
remove the chain cover (1),
loosen the 4 M12 nuts (2),
turn the M12 screw in the chain tightening mechanism (3) so that the chain has a 0.8
"
slack
after tightening,
tighten the 4 M12 screws (2),
install the chain cover.
