Operator’s manual
Bale wrapper
Spin
- 7 -
standing below raised lifting components of the machine,
standing in the machine‘s working area,
maintenance or repairs conducted with the tractor engine on,
use of damaged hydraulic lines,
machine operation by an operator standing outside the tractor‘s cabin,
operating a wrapping machine which is damaged or without protective covers in place,
operating the wrapping machine on slopes with an inclination exceeding 8°,
transporting bales of silage on the wrapping machine,
remaining on (aboard) the machine when it is working or during transport,
misuse of the wrapping machine,
leaving the wrapping machine unsecured on inclined terrain,
standing between the tractor and the machine while the engine is running.
With the aforementioned residual risks, the bale wrapping machine is regarded as a machine
which has been designed and built according to the current state of technology.
Residual risk assessment
Residual risk occurs from not complying with the instructions and safety precautions. Such
risk can be minimized by doing the following:
Read and understand the operating manual,
Do not stand below the raised lifting components of the machine,
Do not stand in the machine‘s working area,
The maintenance and repairs of the wrapping machine should performed at authorized service
workshops,
The machine should be used by trained and authorized operators, Protect the wrapping machine
from access by children and bystanders.
NOTICE:
The residual risks are present when the aforementioned manufacturer‘s
rules and indications are not followed.
During operation, the operator is not subject to noise which may cause the loss of
hearing, as the noise level of the machine does not exceed 70 dB and the operator
works inside the tractor‘s cabin.
During the operation, the operator is not subject to harmful vibration as the vibration
level transferred to the upper limbs does not exceed 2.5 m/s
2
, and the vibration level
transferred to the body is lower than 0.5 m/s
2
and the operator is positioned in the
tractor‘s cabin.
4.3.
Transport
The wrapping machine is suitable for road and rail transport using carriers with appropriate
load bearing capacity.
For loading on a means of road transport, use lifting devices with lifting capacity appropriate for the
machine’s weight including a loaded roll of film. It is forbidden to load the wrapping machine with
a bale of swat or silage on it. The transported wrapping machine must be securely fastened to the
carrier vehicle. It is forbidden to transport the wrapping machine with a bale of silage or swath
loaded on it.
The lifting device should be operated by experienced operators with appropriate
qualifications.
