38
XT
REAR DISC MOWER
OPERATOR'S MANUAL
8.3.
Gear boxes
Before daily work check the oil level and, if needed, refill after having removed the vent
A
30a, b
) on the top of the gear. The oil level can be checked by opening check opening
B
on the side of
the gear. If oil level is too low, refill oil until it is visible in the check opening
B
. The oil capacity in the
110-01.111.L (
), 054-02.10CB.R (
) gears is about 1L. Check the oil level with the
cutterbar set horizontally on the ground. Vent
C
is used for draining of oil.
Fig. 30.
Control and oil changing points of the gear box
To replace oil in gears:
❑
Prepare an adequate tank for the used oil to be disposed,
❑
Open fuel cap
A
❑
Drain oil from the gear by opening drain vent
C
,
❑
Close drain plug
C
,
❑
Refill the oil level until it is visible in the check opening
B
,
❑
Close fuel cap
A.
Tab. 9.
Amount of oil in the gear box
Mower type
Amount of oil [l]
Oil type
Frequency of oil changes
XT 390
1
SAE 80W/90, API GL-4
After first 50 h of operation, then after
next 500 h (or at least once a year)
CAUTION:
The guidelines given above should be carefully adhered to. If the discs of
the cutting unit can by freely spun than the high temperature of the miter gear
should not be a concern since after long periods of work it can reach
temperatures up to 100°C
.
8.4.
Lubrication points
Every 50 hours of the mower's operation, lubricate main joints of the mower and all connections
is cylinders with
STP
grease
.
a)
B
A
C
b)
A
B
C
