Manufacturer settings
Page 30/55
Manufacturer settings
6.1
Basic settings
The basic settings are limited to the correct setting of the timer according to the following table:
Minimum
room size
Maximum
room size
Timer 1
Timer 2
Note
125 m
3
165 m
3
LOW
15
In rooms WITHOUT supply air system
*
165 m
3
210 m
3
LOW
10
In rooms WITHOUT supply air system
*
210 m
3
255 m
3
HIGH
15
In rooms WITHOUT supply air system
*
255 m
3
300 m
3
HIGH
10
In rooms WITHOUT supply air system
*
125 m
3
210 m
3
LOW
5
In rooms with legally designed supply
air/exhaust air system
210 m
3
300 m
3
HIGH
5
In rooms with legally designed supply
air/exhaust air system
*
The
use of the module does not replace the legal requirements for fresh air supply.
Table 7, Timer settings for room size
Operation
7.1
Normal operation
The control unit contains the regulation for the sensor system (function switching on and off) as
well as for the regulation of the high-voltage conversion. The control of the module works automat-
ically.
Switch on the power supply of the ventilation system for the ionisation air purifier
.
This starts normal operation. The plasma module should now operate cyclically for a few seconds
at a time, which can be recognised by a purple glow of the plasma tube as well as a low hum. This
is the typical, normal operating state.
7.2
Switch off
The module is completely switched off by disconnecting the mains plug or interrupting the power
supply, depending on the installation method.
Alternatively, the ventilation system can be switched off completely.
