Doc.-ID: 190402-PT08BA-ES-ExCam XF-Q1785_EN_rev.00.docx, Page 28 of 32
In case it is not possible to assign the IP address, it might be necessary
to change the firewall settings!
The “AXIS IP Utility“ tool automatically recognizes all ExCam devices and displays them
in the device list. It can also be used to manually assign a static IP address. For this pur-
pose, the ExCam XF Q1785 network camera has to be installed in the same physical
network segment (physical subnet) as the computer on which the AXIS IP Utility is run-
ning. The network signature of ExCam XF Q1785 is "AXIS Q1785" (see Figure 7-1). MAC
address and serial number for clear device identification are also detected and displayed.
Fig. 7-1 Axis IP Utility
7.3
Password/ Identification
The following user name is set at the factory:
root
The following password is set at the factory:
root
7.4
How to start the wiper
The ExCam XF Q1785 is equipped with a wiper. The wiper can be started via a button in
the lower right corner of the web interface (see Figure 7-2).
Fig. 7-2 User Interface to operate the wiper
ExCam XF Q1785