Doc.-ID: 190402-PT08BA-ES-ExCam XF-Q1785_EN_rev.00.docx, Page 29 of 32
The factory settings of the wiper are pre-set to wipe 3 times in a row. To repeat the clean-
ing cycle, press the wiper button again. If for any reason the wiper does not function
properly, an error warning appears in the upper-left corner of the user interface and the
wiper automatically attempts to restart every 30 seconds.
The start button for the wiper can be activated or deactivated.
Fig. 7-3 Turning the wiper on
Intermittent wiper controls can be configured via CGI command by the video manage-
ment system. If you have any questions, please write to
8
Maintenance/ Modification
The applicable regulations for the maintenance and servicing of electrical devices in po-
tentially explosive atmospheres must be adhered to.
The required maintenance intervals are specific to the individual devices. The operating
company has to determine these intervals depending on the application parameters. The
maintenance tasks especially include examination of parts on which the ignition protec-
tion depends (e.g., proper condition of the casing, seals and cable entry points). If
maintenance measures are necessary they have to be initiated and/or executed.
8.1
Repair and correction
Repairs may only be carried out with original parts of SAMCON Prozessleittechnik
GmbH. Damaged pressure-resistant housings have to be replaced completely. If in
doubt, send the part in question back to SAMCON Prozessleittechnik GmbH.
Repairs concerning the explosion protection must only be carried out in accordance with
nationally applied regulations by SAMCON Prozessleittechnik GmbH or by an electrical
technician authorised by SAMCON Prozessleittechnik GmbH. Rebuilding of or alterations
to the devices are not permitted.
