Doc.-ID: 220518-PT20BAU-SS-Ex Installation Manual rev.01.docx, Page 8 of 24
3
General safety instructions and special conditions
Attention!
Luminaires of the type liteServer
®
Series T20 are not suitable for use in
zones 0 and 20. The ambient temperature, temperature class, and ex-
plosion group
stated on the enclosure’s type plate, must absolutely be
observed! The customer is not allowed to make any alterations inside
or outside at the housing and must only be used for the intended pur-
pose and in an immaculate condition.
Attention!
Only original parts from SAMCON Prozessleittechnik GmbH may be
used for repair. Repair works affecting the explosion protection may
only be carried out in accordance with the regulations applicable in the
country of use and only by SAMCON Prozessleittechnik GmbH.
Attention!
Prior to installation, please consider external sources of heat or cold!
The permissible temperature range must absolutely be observed!
Attention!
If you use the liteServer
®
in the mining sector with a “high” risk of me-
chanical hazard, you must provide an appropriate device ensuring pro-
tection of translucent components (protective grille, etc.)
Attention!
Observe the warnings given on the type plate!
Note: Depending on the classification of hazard areas, a work approval
must be obtained. When adjusting the lighting fixture, you shall prevent
a potentially explosive atmosphere!
The use in hazardous areas with regard to temperature and dust layers
is defined in the respective national regulations.
Prior to the first use, you should test the luminaire corresponding to the instructions
given in the chapter Commissioning.
Please observe the national safety regulations and regulations for prevention of ac-
cidents, as well as to the safety instructions given below in this User Manual!
