Index revision : B - September 2020
26
7132
•
Step 4
:
Reassembly of the barrel/handle
:
1 Put a light coat of Vaseline in the pow-
der channel duct to facilitate its reas-
sembly.
2 Insert the powder duct, connect the
HVU.
and place the connector under the
HVU,
make sure that the wires loop over the
connectors.
3 Place the barrel against the handle,
starting with the upper part and then
the lower part.
4 Place then screw in the 4 screws and
washers, and tighten crosswise with a
torque of 0.65 N.m.
1
2
3
4