Index revision : B - September 2020
31
7132
•
Step 5
:
Replace the LV cable
.
1 Insert the connector (1) connecting the
HVU into the handle.
Leave enough space to correctly repo-
sition the powder duct.
2 Insert the powder duct into the handle,
making sure not to pinch the wires.
3 Connect the blue connector (2)
connecting the control box.
4 Position the base plate on the handle.
Push the powder duct onto the base
plate.
5 Screw then tighten the assembly with
the 3 KA 30 screws and washers on the
handle with a torque of 0.65 N.m.
6 Reconnect the powder and air hoses.
1
2
