13
7
Storage
Our equipment must be stored in its original packaging.
In case of prolonged storage, it is preferable to carry out preventive maintenance for all
lubricants before start-up.
Storage before installation
Storage ambient temperature 0 / +50 °C (32° F / 122° F).
Protect the complete unit from dust/dirt, water/condensation, moisture, vibration
and shock.
Do not remove the packaging until just before assembly.
Storage after installation
Protect the unit from dust/dirt, water/condensation, moisture and shock.
8
Start-up
Assemble the aircap on the gun by positioning it according to the desired spray
orientation.
Open at the maximum the air needles.
Open the fluid needle as far as i twill go
without a stop.
Connect the air hose.
Assemble the cup or connect the fluid hose.
Pull the trigger and check that the air is circulating normally.
9
Adjustments
This professional spray gun features 3 controls :
Spraying fineness
Air is fed by the central air. The air is adjusted by means of the air regulator
mounted upstream of the gun on the network and more precisely by means of
the knob at the bottom of the gun handle on some manual guns.
Fan width
Fan width is adjusted by using the knurled knob. It controls the air going to the
horns on the aircap. In this way, the air is controlled through the fanned air outlets
and allows the fan to change from flat (wide open) to round (closed).
Fluid output
Having selected the proper fluid nozzle / needle assembly and the fluid pressure,
it is possible to:
Further control the output by changing the travel of the needle (using the needle
stop knob).
Optimal set up is usually obtained when the fluid needle is completely open.
When this needle is nearly closed, a constant flow of fluid cannot be
guaranteed.
