Index revision : C - July 2021
24
7132
7.2.2. Procedure A2: Electrode support.
• Switch off high voltage,
•
Step 1
: Manually unscrew the nozzle nut
then remove the deflector.
•
Step 2
: Remove the electrode support.
•
Step 3
: Clean the electrode support with
compressed air and also the deflector
Make sure that there is no accumulation of
powder.
•
Step 4
: Clean the powder passage duct by
blowing with compressed air.
•
Step 5
: Before reassembling the electrode
support, clean the electrical contact with
compressed air located in the gun.
Check the condition of the O-rings,
replace them if necessary.
DES07319