Index revision : A
14
7129
4.3. Equipment to be connected by the user
WARNING : The connection of the equipment to the ISOCUBE cabinet by the user must conform
to standard NF EN 50348.
4.3.1. Generator connection
•
Step 1:
Run the power supply cable for the generator through a 1st cable gland, then con-
nect it to terminals X1.3 and X1.4
•
Step 2:
Run the generator cable through a second cable gland, then connect it to termi-
nals X1.5 and X1.6
4.3.2. Connection of the cabinet to the installation's general safety loop
•
Step
1: Run the general safety loop cable
through one of the cable glands at the rear
of the box.
•
Step 2:
Replace the bridge between termi-
nals X2.1 and X2.2 by connecting a general
safety loop dry contact.
Cable gland at the rear of the box
Electro-pneumatic box
Power supply cable
connection
Generator cable con-
nection
X1 terminal
X2 terminal
Bridge
