Index revision : D - March 2018
47
7115
11.3. Hollow cone nozzle cleaning
It is vital to clean the spraying head fully at the end of each shift or when use is interrupted,
depending on the type of product between 5 and 30 minutes.
Cleaning procedure
:
•
Step 1
: Disconnect the air and high voltage
supplies. Engage the safety catch on the
trigger.
•
Step 2
: Loosen the cap nut, retrieve the
cap and the low cone and plunge them
into a solvent bath for a few minutes then
clean them with a clean cloth.
•
Step 3
: Using an 11 flat wrench, unscrew the
injector, leave to soak in the solvent then
clean with a clean cloth and a soft brush.
•
Step 4
: Screw the placebo injector fully in
place by hand.
Remove the safety catch and dump the
circuit.
