Index revision : D - March 2018
13
7115
3. Description of spray gun and GNM 6080 control module
The
Nanogun Airmix
®
guns are intended to spray paint or varnish, whose resistivity exceeds
0.5 M
Ω
.cm, to the exclusion of all other paints.
The LR configurations may also spray water-soluble paints or varnishes provided they have
been fitted with the appropriate product feeding systems. The use of any other type of paint is
excluded.
The
Nanogun Airmix
®
guns will be connected to the
GNM 6080
control module.
The versions of the
Nanogun Airmix
®
line are distinct by the base, the paint hose and the
allowable product pressure.
3.1. Functions available based on this gun
• The switch (Rep. 1) allows turning on or off the high voltage supply.
When this switch is placed in position " I ", activating the trigger turns on the high voltage.
When this switch is placed in position " 0 ", activating the trigger does not turn on the high
voltage.
•
The detented knob in back of the gun (Rep. 2) must always be held in place (clockwise);
it does not influence the paint flow rate.
• The side detented knob (Rep. 3) serves to adjust the spray dimension. Its action will
become even weaker as product pressure rises.
Characteristics
Nanogun Airmix
®
120 7.5
Flat spray - 120 bar hose 7.5 m
Nanogun Airmix
®
120 15
Flat spray - 120 bar hose 15 m
Nanogun Airmix
®
120 30
Flat spray - 120 bar hose 30 m
Nanogun Airmix
®
200 7.5
Flat spray - 200 bar hose 7.5 m
Nanogun Airmix
®
200 15
Flat spray - 200 bar hose 15 m
Nanogun Airmix
®
200 30
Flat spray - 200 bar hose 30 m
1
2
3
