Index revision : D - March 2018
38
7115
10.8. Switch
•
Step 1:
With a 5.5-mm screwdriver, unscrew
the washer head screw. Pull the switch lever
upward.
•
Step 2:
Replace the O-ring (
). Insert the new switch into its housing.
Coat the retaining screw with LOCTITE low
strength thread lock and then clamp the
screw so that the switch shows slight resist-
ance.
10.9. Trigger
•
Step 1:
Using a screwdriver, unscrew the two
washer head screws and remove both sides
of the trigger.
Reassembly of the trigger:
• Insert one of the trigger sides onto its shoulder
and then slide the other side into its housing.
Step 1
Step 2
Step 1
