Index revision : D - March 2018
8
7115
2. Health and safety guidelines
WARNING : This equipment may be hazardous if it is not used, disassembled and reassembled
in accordance with the rules indicated in this manual and in any applicable Euro-
pean Standard or national safety regulations.
The warning sign summarising the safety rules (procedures and precautions) of the
present user’s manual must be placed in a visible location within the zone of the
coating product spraying station.
WARNING : The good working order of this equipment is only under warranty provided use of
original spare parts distributed by ”
SAMES KREMLIN
” companies.
2.1. Regulations
The
Nanogun Airmix
®
gun must always be used under the set of conditions required by current
standards and rules as regards the application of paints and varnishes (see the Standards and
Directive EN 50.053 Directive, Part 1 ISO 12100, EN 1953 and 99/92/CE).
In
Canada
, the installation must comply with the Code
"
C22.1 Canadian Electrical Code, Part
I, Safety Standard for Electrical Installations
".
In the
United States
, the installation must comply with the Code
"
NFPA 70: National Electrical
Code
"
.
CAUTION
: Model
Nanogun Airmix
®
spray applicator is suitable for use in
CLASS I, DIVISION 1,
GROUP D HAZARDOUS LOCATIONS”
when connected to model
GNM 6080
power supply unit
.
The
Nanogun Airmix
®
gun has been designed to operate within a 2nd-degree pollution envi-
ronment, as defined according to the Standard IEC-664-1.
2nd-degree pollution:
Under normal use conditions, only non-conductive type pollution arises.
On a temporary basis, conduction caused by condensation may arise.
WARNING : Before using the Nanogun Airmix
®
gun, be sure that all operators:
•
have received preliminary training by the
SAMES KREMLIN
companies,
or by the Dis-
tributors they have certified for this purpose.
•
have read and understood the user’s manual as well as all installation and use rules listed
below.
It is incumbent upon the Operators’ Workshop Manager to ensure and verify that all operators
have read and understood the user’s manuals relative to peripheral electrical devices present
within the spraying perimeter.
2.2. Installation rules
• The hand-held electrostatic projection equipment can only be used in designated pro-
jection spots in accordance with Standard EN 12215 or under equivalent ventilation con-
ditions.
• Install the control module
away from any explosive zone
.
• Servo-control the control module start-up to the “on” position of the booth’s suction fan.
• Correctly connect the control module to the installation’s ground terminal.
• Connect both the pump and paint (or solvent) tank to one of the installation’s ground terminals.
