Index revision : A
31
7116
6.2.3. Procedure B2: Shaping air assembly
• The bell cup has been previously removed.
• Begin to loosen the outer cover with tool P/N 900004396, then continue manually.
• Remove the outer cover, then remove the inner shaping air shroud.
• Carry out a visual inspection of the components (outer cover, shaping air shroud and O-rings),
replace if necessary, then clean the outer cover:
•
Step 1
: Let the outer cover soak in a suitable
rinsing liquid for one hour, then clean the outer
and inner surfaces with a clean cloth soaked in
a rinsing liquid.
•
Step 2
: Use a nylon brush to clean the holes on
the front face of the outer cover.
•
Step 3
: Clean carefully with compressed air
(concentrating on the holes to eliminate product
residues), then wipe with a clean, dry cloth.
• Check the condition of the inner shaping air
shroud and, if necessary, clean it with a cloth
soaked in a rinsing liquid.
• Proceed in reverse order to reinstall the shaping air assembly.
WARNING : Keep the threading between the outer cover and the body clean. Coat the threading
with vaseline to facilitate the reinstallation of the outer cover.
DES03378
Solvent
