Safety instructions
13
2.2
Integrity of the material
Material recommendations
Protectors are put in place for safe use of the equipment.
The manufacturer cannot be held responsible in case of:
Bodily injury.
As well as breakdowns and / or damage to the equipment
resulting from the destruction, the misuse or the total or
partial withdrawal of the protectors.
Pump
It is imperative to be aware of the compatibility of the motors and
pumps before coupling them together as well as the special safety
instructions. These instructions can be found in the instruction manuals
of the pumps.
The air motor is intended to be coupled to a pump. Never modify the
coupling system. Keep hands away from moving parts. The moving
parts must be kept clean. Before commissioning or using the motor
pump, read carefully the DECOMPRESSURIZATION PROCEDURE. Check
the proper operation of the pressure relief and bleed air valves.
Tubing
Recommendations
Keep hoses away from traffic areas, moving parts and hot
areas.
Never subject hoses being produced to temperatures
above 80°C or below 0°C.
Do not use hoses to pull or move equipment.
Tighten all connections and hoses and couplings before
operating equipment.
Check hoses regularly and replace if damaged.
Never exceed the maximum working pressure (MWP) stated
on the hose.
When fitting the hoses and the gun: PPE must be worn.
Tighten to full stop (hoses + gun).
