Revision index: E - May 14
th
, 1998
- 15 -
Code : RT 6015
BF02-02-B - DISMANTLING AND RE-ASSEMBLY OF THE SRV 028-TWIN 60° SPRAY GUN
1 - DISMANTLING
-
It is assumed that the spray gun has already been removed.
- Loosen the screws (25) and (45), and remove the cover (21).
- Loosen nut QD (26), and remove QD plate (13).
- Remove screws (24), (47) and remove shell (20). Remove nut QD (26).
- Disconnect powder feed pipes and compressed air hoses (see plate BF06).
- Remove screws (44), and remove gun assembly (C). Dismantle guns as needed (see plate BF03).
- Remove the two screws (51) maintening the UHT 151-RM (16) on its support (19).
- Remove the four screws (48) and the four sealing washers (49) and remove the HV unit cover (50) in order to access to the
screws (23) maintening the UHT 151-RM (16) on its support (19) (see detail (A)).
- Disconnect the fastens (52) in the UHT 151-RM casing.
- Remove screws (23) and remove the UHT 151-RM (19) equiped with the male plug.
2 - RE-ASSEMBLY
- Check condition of sealing washers (49). Replace it if necessary.
- Place
the
UHT 151-RM (16) on its support (19), then fix it with the screws (23).
- Connecter the fastens (52).
-
Place the UHT cover (50), fix it with the screws (48) equiped with the sealing washers (49).
- Place nut QD (26) on the mobile flange (6).
- Align HV unit cover (19), to HV unit (16), on the mobile flange (6), and secure with the screws (51). Insert gun assembly (C)
into HV unit and secure with two screws (44).
- Connect powder feed pipes and compressed air hoses to gun assembly (C) (see plate BF06).
- Align shell (20) to mobile flange and secure with screws (47) and (24).
- Align cover (21) to shell (20) and secure with screws (25) and (45).
- Align QD plate (13) to mobile flange (6) and secure by tightening nut QD (26).
