16
DRT582221110
B - 2023/01
Member of Exel group
1.5.1. Installation rules
Environment
Environmental risks must be controlled in the following manner:
•Have a qualified electrician check for ground continuity. If ground continuity is not assured, check the
terminal, wire and grounding point. Never operate the equipment without resolving this problem.
•Using a conductive air hose (minimum internal Ø 6.5 mm), connect the gun to connect the gun to the air
supply through a 0-6 bar/ 0-87 psi air regulator.
•The materials to be painted must also be ’grounded’ by means of clamps with cables or, if they are
suspended, by means of hooks that must remain clean at all times.
•Respect the average temperature of use of the equipment and products, which must be at least 5°C /
41°F below the flash point of the products and within a range of 0 to 40°C / 32° to 104°F.
•Ventilation of the area by forced extraction and supply of unpolluted air shall be mandatory during
equipment use of cleaning operations.
•Fragile parts of the installation, and in particular the flexible hoses, must be protected from mechanical
or thermal damage during production or maintenance.
•The waste related to the operations or the dismantling of the equipment will have to be treated
according to the laws in force.
•The noise level of our equipment is limited to the maximum.
•However, the operators will have to be protected according to the global noise level of the environment.
•Depending on the operating conditions, the sound pressure of the equipment may cause hearing
damage.
•Take appropriate measures to reduce noise pollution.
•Dispose of packaging materials in an environmentally friendly manner.
ATTENTION
Danger to personnel if improperly installed.
•The exact delimitation of the zones is the express responsability of the user, depending on the
products used, the environment of the equipment and the condition of use.
•Select the pump so that the fluid pressure delivered by the pump is appropriate for the type of gun
selected.
•By means of an high pressure hose, connect the paint fitting on the gun to the pump. Tighten the
fittings. firmly.
•The pressure resistance of the hose must be greater than or equal to the pressure delivered by the
pump.
•In some special cases, if the air hose is non-conductive, the material hose must be conductive.
•It is imperative that one of the 2 hoses (air or material) of the gun is conductive.