17
Member of Exel group
DRT582221110
B - 2023/01
1.6. Important recommendations
1.6.1. Non-intended use or foreseeable misuse
Any use other than the use described in the paragraph, ’Intended use’ and in this operating manual, and any use that
extends beyond the specified intended use, shall apply as non-intended use. The manufacturer shall not be liable
damage resulting from non-intended use. This risk is borne solely by the user.
The following points describe improper or prohibited use:
• Conveyance of fluids that does not meet the product specification.
• Modify or alter the gun, in any way.
• Use a damaged gun.
• Use, maintenance, repair of the installation or commissioning of the gun by unauthorized, untrained personnel
or by a private user.
• Use the gun without grounding,
• Use the gun outside the indicated parameters / service data.
• Use the gun in a place where there is a risk of ignition due to ignition sources in the vicinity of the gun.
• Failure to observe the maintenance intervals.
• Immerse the gun in solvents or aggressive products.
• Operating the gun in potentially explosive gas or dust areas of zone 0 or operating it in potentially explosive
areas without the operator having first taken measures in accordance with the requirements of
Directive 1999/92/EC and the applicable national regulations on explosive protection.
• First start-up without prior inspection fo the area and the gun by an authorized person.
• Use of products that are chemically incompatible with the materials used in the construction of the gun: the
operator of the gun must check the chemical compatibility of the products conveyed.
• Use of products whose characteristics (e.g. ignition temperature) are not compatible with the gun identification.
• Bypassing safety devices of the gun.
ATTENTION:
Never wipe the end of the tip with the fingers.
Do not point the spraying gun at people or animals.
Always use the safety trigger lock when leaving the gun unattended.
Danger to personnel - Risk of product injection.
1.6.2. Compressed air quality
Not applicable
1.6.3. Transport
The gun should only be transported in its original packaging to avoid transport damage.
1.6.4. Check the scope of delivery
• Remove the gun from its packaging.
• Dispose the packaging properly. Comply with the rules in force in your locality.
• Check that the gun has not been damaged during transport.
• Transport damage must be immediately communicated to the transport company and
Sames
in writing.
• Protect the gun from further damage.
• Use the packing slip to verify the completeness of the delivery.
