33
Member of Exel group
DRT582221110
B - 2023/01
6.3. Maintenance
ATTENTION: Before any intervention, respect the health and safety instructions see § 1 page
7.
Please refer to the Preventive Maintenance Plan see § 10.1 page 63 for more information.
6.3.1. Maintenance and monitoring periods
It is recommended to schedule a routine maintenance after a set number of hours of operation.
This is defined by the user’s maintenance department and is based on the product, the work rate and the usual
pressure.
The maintenance consists of replacing parts with cuts or wear and cleaning organs with compatible products without
using abrasive materials that could damage them.
The O-rings are mounted with special ’pneumatic’ grease. Make sure that none of them get damaged; cutting one of
them may cause the gun to malfunction.
Be familiar with disassembly/reassembly procedures and spare parts.
6.3.2. Cleaning
It is recommended to clean the gun with compatible products without using abrasive materials that could damage it.
ATTENTION:
Never wipe the end of the tip with the fingers.
Always use the safety trigger lock when leaving the gun unattended.
Danger to personnel - Risk of product injection.