22
Member of Exel group
DRT7159
B - 2023/03
7. Use of Inocart VT or H equipment
7.1. Powder application
As the equipment has already been installed according to the safety rules (
) and the instructions
), follow the steps described below:
•
Step 1
: Connect the ground cable of the cart to a conductive and earthed part of the spray booth; the ground
potential must be identical to that of the part to be powdered.
•
Step 2
: Electrically and pneumatically power the equipment.
•
Step 3
: Position the open powder box on the vibrating table or put powder in the hopper.
•
Step 4
: Switch on the
Inobox
control module (
) (ON button on the front of the module).
•
Step 5
: (
) to adjust the application settings for the parts to be powdered on the
Inobox
module. It is possible to adjust the powder flow rate directly on the gun.
•
Step 6
: Point the gun nozzle towards the booth and the part to be powdered and press the trigger.
•
Step 7
: For the vibrating table version, close the plastic bag containing the powder around the plunger tube
(
Summary of Contents for Inocart VT
