23
Member of Exel group
DRT7159
B - 2023/03
8. Maintenance
Note: This paragraph applies only to the maintenance of the Inocart cart.
For specific maintenance of the gun (
) and the Inobox control module (
Disconnect the power supply to the control module before connecting the gun. Before
disconnecting the gun, switch off, cut off the power supply to the control module (otherwise
a malfunction may occur).
8.1. Maintenance summary table
The soiling and wear of the different elements of the
Inocart
carriage caused by the passage of the powder depends
on the nature of the powder and the operating conditions.
Therefore, the periodicity of maintenance indicated in the procedures below is only indicative. The user will have to
create his own maintenance range as he uses the
Sames
equipment.
Procedure
Detail
Duration
Frequency
Cleaning
A
Cleaning of the cart
2 mn
8 Hours
B
Powder pump / plunger tube cleaning
2 mn
8 Hours or at each
color change
Replacement
C
C1
Replacement of filter
30 mn
-
C2
Replacement of vibrator
1 Hour
-
C3
Replacement of elastic pads of the vibrating table
5 mn
-
C4
Fast Clean replacement
5 mn
-
C5
Replacement of the equipped porous washer
15 mn
-
Summary of Contents for Inocart VT
