Revised A
41
6301
5. Maintenance (continued)
5.3.4 Low voltage cable wiring instructions (continued)
Step 10:
Secure the electrical connector assembly with the (4) plastic screws.
Step 11:
Feed cable ends through the 5/16” nylon tubing.
Step 12:
Place the nylon tubing inside the connector and secure with connector and 2 S/S screws.
5.3.5. UHT 153 Cascade
Note:
• After installing the UHT 153 into the quick disconnect, apply a light film of dielectric grease to the
rod and high voltage contact before installing the PPH 607 manifold.
• Be sure to tighten the cascade set screw to prevent the cascade from falling out and breaking.
High voltage
contact
Zero degree indexing position
Cascade set screw
