2023_03_15-11:00
3
R. 03/23 896 854
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
EN
MOUNTING AND INSTALLATION
• Set the minimum air pressure that allows the pump to
supply fluid to the control valve
• Check for leaks and that no fluid is dispensed through
the nozzle.
• Push the trigger. The fluid should be dispensed through
the nozzle once network air is eliminated.
1. Adjust line pressure until reach desired value.
DISPENSED
Perform the following procedure after installing
the control valve to verify proper operation:
To dispense fluid, proceed as follows:
Fig. 2
1
2
• With the trigger at rest position, check that there are no
leaks and that fluid supply is stopped. Due to fluid
accumulation in the extension, fluid dripping may
occur after stopping dispensing.
OPERATING MODE
2. The gun has a safety lock system that prevents
accidental opening. If the cam located in the middle of
the trigger is in the anti-open position, place it in the
open position to begin dispensing.
WARNING:
Do not exceed the maximum
equipment working pressure. See page of
technical specifications.
!
