4
850 823 R. 05/21
SAMOA Industrial, S.A. · Pol. Ind. Porceyo, I-14 · Camino del Fontán, 831 · 33392 - Gijón - Spain · Tel.: +34 985 381 488 · www.samoaindustrial.com
2021_05_03-13:00
EN
1.
With the hose fully wound on the spool and the hose stopper touching
the rollers, turn the spool enought to be able to reach the ratchet
assembly. Make sure to avoid the spool to turn freely, blocking it safely.
2.
Loosen the 2 bolts (1) (fig. 6), and the 4 nuts (2) (fig. 6). Remove the
ratchet assembly.
3.
Clean the components, or replace the ratchet assembly with a new one.
4.
Assemble the ratchet assembly in place and tight the 2 bolts (1) (fig.
6), and the 4 nuts (2) (fig. 6).
5.
Make sure the ratchet assembly works properly.
LATCH REPLACEMENT
1.
Disconnect the hoses of the inlet shaft (1) and the swivel
joint (2) (fig. 7).
2.
Loosen the set screw in the nut (3) and remove said nut.
3.
Remove the screws (4) and the arm (5).
4.
Remove the swivel and replace it with a new one, or replace the seals.
Make sure the seals are placed correctly (fig. 8).
5.
Grease the interior of the swivel and place it carefully back on the shaft
until it touches the bearing on the spool.
6.
Place back the rest of parts in reverse order.
Fig. 8
2
1
3
Fig. 7
3
4
4
5
SWIVEL REPLACEMENT
SYMPTOM
POSSIBLE CAUSES
SOLUTION
Hose does not rewind.
Spring is not tensioned enough.
Increase spring tension.
Leaking hose reel.
Hose has a hole or is damaged.
Replace the hose.
Leaking swivel.
Damaged swivel rings.
Replace the swivel rings.
Hose does not extend out as much as required.
Spring is over tensioned.
Decrease spring tension.
Hose reel does not latch.
Damaged ratchet.
Replace the ratchet.
Ratchet not fitted.
Assembly the ratchet properly.
Damaged spring ratchet.
Change the ratchet spring.
TROUBLESHOOTING
Fig. 6
1
1
2
2
