www.larius.com
13
L400
REV.
02 - 02/2020 - Cod. 150085
CONNECT AIR HOSE
• Connect the flexible hose
(P1)
to the fitting of air gauge
(P2)
of the pump.
• Connect the flexible hose
(P1)
to the fitting
(P3)
of the gun.
GROUNDING
To reduce the risk of static sparking, ground the pump and all
other equipment used or located in the dispensing area. Check
your local electrical code for detailed grounding instructions for
your area and type of equipment and be sure to ground all of
the following equipment.
• Pump: ground the pump by connecting a grounding wire from
the pump’s grounding lug to a true earth ground.
• Air compressor or hydraulic power supply: ground according
to local code and manufacturer’s recommendations.
• Fluid hoses: use only grounded hoses with a maximum of 150
mt. Combined hose length to ensure grounding continuity.
Refer to hose grounding continuity, above.
• Flo-gun: obtain grounding through connection a properly
grounded fluid hose and pump.
• Fluid supply container: according to local code.
• All solvent pails used when flushing: according to local code.
Use only metal pails. Do not place the pail on a non-conductive
surface, such as paper or cardboard, which interrupts the
grounding continuity.
• To maintain grounding continuity when flushing or relieving
pressure always hold a metal part of the gun firmly to the side
of a grounded metal pail, then trigger the gun.
Moving parts can pinch or amputate your fingers or other body
parts. Keep clear of moving parts when starting or operating your
system.
Before checking or servicing the gun, pump, or any other system
component follow the PRESSURE DISCHARGING PROCEDURE
to prevent the pump from starting accidentally.
Before flushing, be sure the entire system and
flushing pails are properly grounded. Refer to
GROUNDING, above. Always use the lowest
possible fluid pressure, and maintain firm metal-
to-metal contact between the gun and grounded
metal pail during flushing to reduce the risk of fluid
injection injury, static sparking and splashing
.
MOVING PARTS HAZARD
O
SETTING UP
P
P1
P2
P1
P3
