www.larius.com
9
L400
REV.
02 - 02/2020 - Cod. 150085
• NEVER SPRAY OVER FLAMMABLE PRODUCTS OR SOLVENTS
IN CLOSED PLACES.
• NEVER USE THE TOOLING IN PRESENCE OF POTENTIALLY
ExPLOSIVE GAS.
• USE EXTREME CAUTION WHEN CLEANING OR CHANGING
THE FLUID NOZZLE. IF THE NOZZLE CLOGS WHILE DISPEN-
SING, FULLY RELEASE THE TRIGGER IMMEDIATELY. ALWAYS
FOLLOW THE PRESSURE RELIEF PROCEDURE, bELOW,
bEFORE WIPING OFF bUILD-UP AROUND THE NOZZLE OR
REMOVING THE NOZZLE TO CLEAN IT.
DO NOT USE METAL TOOLS TO CLEAN THE NOZZLES,
SINCE THEY MAY bE SCRATCHED AND CAUSE UNEVEN
SPRAYING.
DO NOT RUb THE SPRAYGUN WITH CLOTHS
SOAKED IN SOLVENT
IF THE PRODUCT TO BE USED IS TOXIC, AVOID
INHALATION AND CONTACT BY USING PRO-
TECTION GLOVES, GOGGLES AND PROPER
FACE SHIELDS.
TAKE PROPER SAFETY MEASURES FOR THE
PROTECTION OF HEARING IN CASE OF WORK
NEAR THE PLANT.
DO NOT POINT THE GUN UPWARDS
DURING CLEANING OPERATIONS.
The high speed of the product in the hose can
create static electricity through discharges and
sparks. It is suggested to earth the equipment.
The pump is earthed through the earth cable of
the supply.
The gun is earthed through the high pressure
flexible hose.
All the conductors near the work area must be
earthed.
Always check the product is compatible with the
materials composing the equipment (pump, spray
gun, flexible hose and accessories) with which it
can come into contact. Never use paints or sol-
vents containing halogen hydrocarbons (as the
methylene chloride).
If these products come into contact with alu-
minium parts can provoke dangerous chemical
reactions with risk of corrosion and explosion.
DO NOT IMMERSE THE SPRAYGUN IN SOLVENT.
