www.larius.com
12
GHIBLI 10:1
ED.
05 - 10/2020 - Cod. 150154
P3
P2
P4
P1
NOTE
Check the gaskets:
replace if worn
• Carefully screw again the fluid cylinder (
it is suggested to lay
a slight film of vaseline grease on the internal walls of the fluid
cylinder
).
REPLACEMENT OF THE
LOWER GASKETS
• Unscrew and remove the fluid cylinder (
P1
).
• Hold the bush (
P2
) with a wrench and with the other wrench
unscrew the fitting (
P3
).
• Exctract the necessary lower gaskets (
P4
), supplied as spare
parts.
• For the reassembling of the gaskets, respect the order as
shown in the drawing.
REPLACEMENT OF THE
UPPER GASKETS
• Unscrew and extract the fluid cyclinder (
Q1
).
• Unscrew the three nuts (
Q2
).
• Remove the split pin (
Q3
) and unscrew the piston rod from
the pneumatic motor. Disconnect the pumping group from
the pneumatic motor.
P
Close the compressed air supply to the pump
and release the residual pressure in the plant.
Close the compressed air supply to the pump
and release the residual pressure in the plant.
Q
