www.larius.com
9
GHIBLI 30:1/40:1
REV.
. 01 - 03/2020 - Cod. 150088
H
H1
H2
H1
• NEVER SPRAY OVER FLAMMABLE PRODUCTS OR
SOLVENTS IN CLOSED PLACES.
• NEVER USE THE TOOLING IN PRESENCE OF POTENTIALLY
EXPLOSIVE GAS.
Always check that the product is compatible with
the materials composing the equipment
(pump,
spray gun, flexible hose and accessories)
with which
it can come into contact. Never use paints or
solvents containing Halogen Hydrocarbons
(as
the Methylene Chloride)
. If these products come
into contact with aluminium parts can provoke
dangerous chemical reactions with risk of
corrosion and explosion.
Avoid approaching too much to the pump piston
rod when the pump is working or under pressure.
A sudden movement of the piston rod can cause
wounds or finger squashing.
If the product to be used is toxic, avoid inhalation
and contact by using protection gloves, goggles
and proper face shields.
Take proper safety measures for the protection
of hearing in case of work near the plant.
CONNECTION OF SUCTION AND RECIRCULATING PIPES
• Connect the suction and recirculating pipes to the pump.
The suction hose can be locked finger tight
(H1)
.
Use a spanner
to tighten the recirculating pipe
(H2)
.
In both cases do not use
sealant agents for fitting threads.
SETTING-UP
CONNECTION TO THE FEED AIR
• For pump feed use a hose
(H1)
with an internal diameter no
lower than 10 mm.
Fig. 1H
Fig. 2H