www.larius.com
7
VIKING
ED. 03 - 09/2020 - Cod. 150163
Should anyone use an extension cable between
the tooling and the socket, it must have the same
characteristics as the cable supplied
(minimum
diameter of the wire 2.5 mm2)
with a maximum
length of 50 mt. Higher lengths and lower
diameters can provoke excessive voltage falls
and also an anomalous working of the equipment.
• The supply cable is provided without plug.
Use a plug which guarantees the plant earthing.
Only a technician or a skilled person should perform the
connection of the plug to the electric cable.
CONNECTION OF THE TOOLING TO THE POWER SUPPLY
• Check the
ON/OFF
switch
(H2)
is on the
"OFF"
position
(0
)
before connecting the cable to the mains.
• Place the pressure control knob
(H3)
on the
“MIN”
position
(turn counterclockwise)
.
OFF
0
WASHING OF THE NEW EQUIPMENT
• The equipment has already been adjusted at our factory with
light mineral oil left inside the pumping group as protection.
Therefore, wash with diluent before sucking the product.
• Lift the suction pipe and dip it into the solvent tank.
• Ensure the gun
(H4)
is without nozzle.
• Open the re-circulation tap
(H5).
Turn the unit
ON-OFF
switch
(H6)
on the
"ON"
position
(I)
.
• Rotate the pressure setting knob
(H7)
slightly clockwise so
that the machine operates at minimum power.
H3
H3
H4
H5
H6
H2
H7
H7
Fig. 3H
Fig. 4H
Fig. 5H
Fig. 6H
Fig. 7H
Fig. 8H
Fig. 9H
