SamplexPower SEC-1212P, Owner'S Manual

6  |  SAMLEX AMERICA INC. 

SECTION 2  

|  Layout & Dimensions

2.2 SEC-1223P AND SEC-1235P

4

3

4

3

1

7

5

Overall Dimension: 185 x 208 x 57.8 mm

(with protrusions)   7.28 x 8.19 x 2.28 in

[W x D x H]

6

Bottom View

190

57.8

180

180

185

2.5

2.5

208

4.5

53.3

2

8

Figure 2.2 Layout & Dimensions - SEC-1223P & SEC-1235P

LEGEND for Fig 2.2

1. Lighted Power ON/OFF Rocker Switch (Lights Red when ON)

2.  AC Power Cord Inlet: Type “IEC 60320-C14” for detachable power cord with 

“IEC 60320-C13” connector on one end and country specific plug on the other end.

3. Black Negative (-) DC Load Terminal

Ÿ

   Tubular hole Dia 5mm/0.2” and set screw (5/64” Hex Socket Head, #10, 24 TPI, 

5/16” long)

*See Note 2

4. Red Positive (+) DC Load Terminal

Ÿ

   Tubular hole Dia 5mm/0.2” and set screw (5/64” Hex Socket Head, #10, 24 TPI, 

5/16” long)

*See Note 2

5. Air inlet slots on the top cover for cooling fan suction

6. Air inlet slots in the bottom for cooling fan suction

7.  Lanced tab that slides into corresponding slot in the bottom housing. (There is one more 

lanced tab on the other corresponding side of the top cover). This ensures that the top cover 

fits properly only in one orientation i.e. with ventilation slots  5  positioned away from the fan 

discharge openings  8 . 

8.  Ventilation openings for fan discharge (outwards). Fan is located behind the ventilation openings.
NOTES:  1.  The top cover will fit properly only when the 2 lanced tabs (7, Fig 2.2) are oriented 

towards the DC output terminals  3  and  4  .

2(a).  5/64” Hex Key and 2 spare set screws have been provided.

2(b).  2 pieces of Pin Type Terminals (for wire size up to AWG#8) have also been provided for 

crimping to bare stranded wire ends of load wiring for firm contact under the set screws.