4
© 2023 Samsara Inc.
3
Connect the wires using the following pinout list as a guide:
Red cable (Power):
It is recommended to wire to a key switched source, such as an hour meter or oil pressure switch for internal
combustion engines.
Black (Ground):
Verify a ground point using a multimeter, typically a metal stud or bolt that makes a direct contact to the metal
chassis.
Green-white (Input 1):
Use for tracking hours of operation. Input examples: hour meter, oil pressure switch, etc.
Blue-white (Input 2):
Use for tracking productivity or alerts. Input examples: hydraulic solenoid on belt loader to track productivity
when compared to engine hours
Orange (Output):
Reserved for future use
Green (CAN Lo)/Yellow (CAN Hi):
Not currently supported for AG52. For AG26 only.
4
After you connect the Asset Gateway to power,
verify the connection in the Samsara Dashboard.
After a successful connection, the LED will turn
green.
▄
Purple
First Boot
▄
Green
GPS & LTE OK
▄
Blue
No GPS, LTE OK
▄
Red
No GPS, No LTE
▄
Yellow
No LTE, GPS OK
Orange (Output): Reserved for future use
Green (CAN Lo)/Yellow (CAN Hi): Not currently supported for AG52. For AG26 only.