Samson PowerStrip PS10, Owner'S Manual

6

PB10 Guided Tour - Front Panel

1

4

2

3

5

3

6

 PowerBrite PB10 Front Panel 
1:   Circuit breaker-

 This circuit breaker will trip whenever the total load on the PB10 

(all rear panel switched outlets plus the front panel unswitched convenience 

outlet) exceeds 10 amps.  To reset it, unplug one or more devices so as to reduce 

the load and gently press the circuit breaker in until you hear it click.

Note: 

It may take a minute to cool before you can reset it. 

2:    Dimmer -  

Use this to adjust the level of the LED light in the slide-out Lamps.

3:     Lamps- 

Contains the PB10’s 5-LED light.  Use the Dimmer control (see #2 above) 

to adjust the brightness of the lamps.  To turn off the lamp, gently slide the lamp 

back in.  

4:  Vents- 

Convection cooling is accomplished by the front panel vent holes.

5:   Unswitched convenience outlet- 

This IEC outlet is active whenever the PB10 is 

plugged in, regardless of the setting of the Outlets switch (see #6 below).

6:   Outlets switch- 

Use this to turn the rear panel outlets on or off. When on, the 

lamp inside this switch lights red.