12
Control Functions and Indicators
SYSTEM LEVEL Up and Down
Controls
The volume control is used to adjust the
amount of level to the R10s subwoofer. In
addition, the volume control will also control
the output level of the high-pass outputs.
Therefore, if you are using the R10s without
using the high-pass outputs, the volume
control adjusts the low frequency output of
the R10s. If you are using the R10s’s internal
electronic crossover to run satellite speakers,
then the volume control will adjust the overall
system level.
FREQUENCY
The FREQUENCY control selects the upper
range cutoff frequency of the R10s’s internal
electronic crossover with a range of 40 Hz to
180 Hz. The R10s’s crossover provides a 12dB
per octave, Linkwitz Riley filter curve. The
FREQUENCY adjusts the highest frequency that
the R10s will reproduce, and at the same time,
the high-pass outputs track the selected cross-
over frequency as the lower limit frequency to
the satellite speakers.
PHASE Switch
The R10s can be switched for inverted phase
operation by setting the PHASE SWITCH to the
180° (degree) position. Experiment with this
switch to provide the best blend between the
subwoofer and satellite speakers.
12
Operating the Rubicon R10s
7
8
9
7
8
9
Summary of Contents for Rubicon R10s
Page 1: ...S T U D I O R E F E R E N C E M O N I T O R S 150 Watt Active Sub Woofer...
Page 18: ...18 Notes...
Page 19: ......
