12
STEP 14
Fitting of Gutter End Caps
Ensure the gutter is completely dry, then apply a continuous bead of Sudaflex around the end of the
gutter extrusion, then line up the 4 holes on the gutter end plate with the port holes on the end of
the gutter section and using 4 No. x 5/8'' self tapping screws secure in place. Finally using a
dobbing stick or finger with disposable gloves apply a bead around the internal gutter section at the
end. Repeat at the other end. Please see diagrams below:
STEP 15
Fitting of Wall Plate End Caps
Line up the 2 No. holes on the wall plate end plate with the port holes on the end of the wall plate
section and using 2 No. x 5/8'' self-tapping screws secure in place. Repeat at the other end. Please
see diagram below:
STEP 16
Make Sure Your Canopy/Carport is Square
To ensure the carport is square, using the roofing square, attach one edge of the square to the wall
plate and the other edge will need to continuously touch the other edge of the square. This will
ensure the gutter beam is perpendicular to the wall plate.
STEP 16a
Ensuring your Canopy/Carport is Level
Using a spirit level ensure the front beam is completely level and your posts are plumb.
01933 448850
www.samsondoors.co.uk
09/19
01933 448850
www.samsondoors.co.uk
09/19
