Samson Stage 200, Owner'S Manual

14

Issue

Solutions

No Audio

Turn on the VH200 transmitter using the Power/Mutr switch.
Ensure the VH200 transmitter’s batteries are installed correctly.
Confirm that the SR200 adaptor is correctly connected and 
plugged into an electrical outlet.
Turn on the SR200 receiver.
Make sure the SR200 output and audio input connections 
are securely connected.
Ensure that the SR200 receiver and VH200 transmitters are 
in line of sight with one another. 
Check the receiver and audio input device level controls. 

Distorted Audio

Check the receiver output level and audio input device level.
Check the VH200’s batteries and replace if low.
Another transmitter may be broadcasting on the same channel. 
Turn off transmitter that may be causing interference. 

Audio Dropout

The transmitter may be too far away from the receiver. Move 
closer to the receiver, or reposition the antennas.
Remove any sources that may cause RF interference, such as 
cell phones, cordless phones, lighting equipment, computers, 
etc.

Transmitters and 
Receiver on Different 
Channels

Contact your Samson reseller or distributor for assistance. 

Troubleshooting