1
Safety instructions
For your own safety, follow these instructions concerning the mounting, start-up and operation
of the controller:
4
The device may only be mounted, started up or operated by trained and experi-
enced personnel familiar with the product.
4
The controller has been designed for use in electrical power systems. For wiring and
maintenance, you are required to observe the relevant safety regulations.
To avoid damage to any equipment, the following also applies:
4
Proper shipping and appropriate storage are assumed.
1.1
Start-up
To start up the controller, follow the instructions below in the order described.
1.
Install the controller and connect the wiring. Refer to sections 10 and 11.
NOTICE
The wiring differs depending on the system. Refer to sections 5 and 11.
After the controller is connected to the power supply for the first time, a start-up wizard au-
tomatically starts. This start-up wizard guides the user to set up the controller and select the
language, system time and system code number. After start-up, the controller is ready for
use.
The user can change the settings at any time. Refer to sections 3.3, 3.6 and 3.7.1.
2.
Activate required functions and deactivate any functions that are not required. Refer to
section 3.7.2.
3.
Set the parameters. Refer to section 3.8.
4.
Enter the set points and deactivation values. Refer to section 3.1.
EB 5610 EN
7
Safety instructions
Summary of Contents for trovis 5600
Page 22: ...22 EB 5610 EN Setup settings B C D A A...
Page 124: ...124 EB 5610 EN...
Page 125: ...EB 5610 EN 125...
Page 126: ...126 EB 5610 EN Key number 1732...
