104
EB 8384-6S EN
Operating the positioner
7.6.1 MAX – Initialization based on maximum range
The positioner determines travel/angle of rotation of the closing member from the CLOSED
position to the opposite travel stop and adopts this travel/angle of rotation as the operating
range from 0 to 100 %.
Enable configuration:
Configuration is locked again if no settings are entered within 120 s.
1. Turn
until Code 3 appears (reading:
No
).
2. Press , the code number 3 blinks.
3. Turn until
YES
appears.
4. Press
to confirm (reading:
).
Enable configuration
Default: No
Enter the pin position:
1. Turn
until Code 4 appears.
2. Press , the code number 4 blinks.
3. Turn to select pin position on lever (see
relevant section on attachment).
4. Press
to confirm.
mm
Pin position
Default: No
Select the initialization mode:
1. Turn
until Code 6 appears.
2. Press , the code number 6 blinks.
3. Turn until
MAX
appears.
4. Press
to confirm the MAX initialization
mode.
Default: MAX
Start initialization:
Î
Press INIT key.
After initialization, the maximum travel/angle of rotation (Code 5) which was detected
during initialization is indicated.
Summary of Contents for TROVIS SAFE 3730-6
