14
Operating the XM410
USING AN EXTERNAL EFFECT
If you prefer to use an external device for effects process-
ing, you can easily connect the unit using the XM410
EFX bus. Follow the simple steps below to interface your
processor:
1. Set the MONITOR section VOLUME control to the "0"
position.
2. Raise the EFFECT controls for the channels to which
you want the external effect to be applied.
3. Now adjust the EFX LEVEL to about half way.
4. Set the input level of the external effect so that the
sound is not distorted and so that the effect’s input
meter does not indicate a clipped signal.
5. Use the AUX IN control to adjust the level of the effects
processed by the external effects device.
PLAYING BACK A CD
T
he XM410 has a dedicated input for playing back a CD,
Tape or Mini Disk. Below is a description of how you
can play back a CD, Tape or MD using the XM410’s TAPE
INPUT.
1. Turn the TAPE IN level control and the VOLUME level
control all the way down.
2. Follow the "LAST ON, FIRST OFF" rule and turn on your
peripheral devices and then the power on the XM410.
3. Adjust the VOLUME control of the MAIN section to the
"5" position.
4. Start playback on the CD, Tape or MD player, and use
the TAPE IN control to adjust the level so that the zero
LED of the MAIN section peak level meter lights occa-
sionally. Adjust the master volume control to raise the
level if necessary.
RECORDING FROM THE XM410
You can record the audio from the XM410’s mixer section
including the MIC, LINE, TAPE IN and AUX inputs to a cas-
sette deck, MD, DAT or any other type of recorder using the RECORD outputs. Simply connect the XM410’s
REC OUT to the input jacks of the recorder as shown in the diagram above.
