6
XP308i Mixer Layout
XP308i Front View Layout
9
10
11
12
13
14
17
18
19
24
23
22
21
20
16
15
2
1
3
4
5
6
7
8
1. MIC – XLR connector (channels 1 - 4)
Use these XLR jacks to connect low impedance
microphones to the XP308i’s built-in mic preamps.
2. LINE - ¼-inch phone connector (channels 1 - 4)
Use these 1/4” jacks to connect instrument or audio
source with line-level signals to the XP308i. You can
connect the outputs from acoustic guitar pickups,
keyboards, drum machines, CD/MP3/TAPE players
and other units with line level outputs here.
3. MIC/LINE – switch (channels 1 - 4)
The MIC position changes the gain of both input
jacks to MiC level. The LINE position reduces the
gain of both jacks by 30dB to line level.
4. HIGH FREQUENCY(HF) – control knob
The HF knob controls the amount of treble
applied to that channel. The channel’s HIGH
frequency response is flat when the knob is in
the “12:00” position. Rotating the knob towards
the right will boost the channel’s high frequency
response above 10 kHz by 15dB, and rotating
it towards the left will cut the high frequency by
15dB.
5. LOW FREQUENCY (LF) – control knob
The LF knob controls the amount of bass applied
to that channel. The channel’s LOW frequency
response is flat when the knob is in the “12:00”
position. Rotating the knob towards the right will
boost the channel’s low frequency response below
100 Hertz by 15dB, and rotating it towards the left
will cut the frequency by 15dB.
6. REVERB – switch (channels 1 - 4)
Use the REVERB switch to add a reverb effect to
a mic or line input on any of the inputs 1 – 4. The
REVERB switch is used in conjunction with the mas-
ter REVERB return control knob #23.
7. REVERB LED – indicator (channels 1 - 4)
The REVERB LED will illuminate when the REVERB
switch is pressed down indicating the channel is set
to add reverb. See number 6 above.
8. VOLUME (VOL) – control knob
Sets the overall level for the Mic or Line input.
9. Stereo Inputs (channels 5 / 6)
The XP308i has a pair of 1/4-inch jacks for connect-
ing stereo line level sources. For stereo inputs ,use
the LINE L to connect the left channel and the LINE
R to connect the right channel. Use these inputs to
connect high impedance microphones, synthesizers,
drum machines, MP3, CD, tape players or any other
line level device.
