XPD2M Dual Channel Digital Wireless
10
In order for the XPD2m Dual Channel Digital Wireless System to work correctly, both
the RXD2M receiver and HXD1 handheld or PXD1 beltpack transmitter must be
paired together. (NOTE: The XPD2m Digital Wireless System will come paired from
the factory).
Follow this basic procedure for setting up and using your XPD2m Digital Wireless
System:
1.
Physically place the RXD2M receiver where it will be used. We suggest you keep
receiver and transmitter within line of sight for optimal performance, meaning
the performer using or wearing the transmitter can see the receiver.
2.
Connect the included power adapter to the RXD2M receiver before turning the
power on. Turn the RXD2M on momentarily to confirm that it is receiving power,
then turn it off (figure 1).
3.
With your amplifier or mixer powered off and
volume control down connect the RXD2M
receiver Channel 1 output jack to the mic or
line input using the balanced XLR output,
unbalanced 1/4” or 1/8” output jacks. Turn
the RXD2M power on but keep the volume at
minimum level (figure 2).
4.
Place a fresh set of AA (LR6) batteries in the
transmitter’s battery compartment being sure to observe polarity markings (figure
3).
Quickstart
Figure 2
Figure 3
Figure 1