13
For further information, visit videotron.com/terminal-support.
pRoGRAM yoUR REMoTE CoNTRoL
To get the most out of your new terminal, we recommend that you read the next few pages to
ensure that you properly program your remote to your TV.
There are three ways to program your remote control:
1.
Quick programming: for your TV only.
2.
Programming using automatic search: for your TV or audio system.
3.
Programming by code: for your TV or audio system.
qUICk pRoGRAMMING of yoUR REMoTE CoNTRoL
If your TV brand is not among the 10 brands listed below, please use the Automatic Search
Programming Method described on the next page.
1. Turn on your TV.
2. Hold down
and
at the same time until the red light under
blinks twice, then
release both buttons.
3. Press
once. The red light will stay lit.
4. Point the remote control at the TV. Refer to the table below and enter the number
corresponding to the brand of your TV (e.g. 2 for LG). The red light will blink twice and the
TV will turn off.
5. Press
to lock the code.
6. Turn your TV back on. If this programming procedure did not work, repeat steps 2 to 5 or use
the Automatic Programming procedure described on the next page.
7. When your remote control has been programmed, we strongly recommend that you change
the volume control on the TV via the Equipment Settings (see the
Equipment Settings
section
on page 16).
NUmBER
HD TV BRANDS
NUmBER
HD TV BRANDS
1
INSIGNIA
6
SAMSUNG
2
LG
7
SHARP
3
MITSUBISHI
8
SONY
4
PANASONIC
9
TOSHIBA
5
PHILIPS/MAGNAVOX
0
VIZIO
