15
For further information, visit videotron.com/terminal-support.
pRoGRAMMING yoUR REMoTE CoNTRoL wITH A CoDE
Follow the instructions below if you would like to program the remote control to your TV and
audio system.
1. Turn on your TV or audio system. Program your TV first.
2. Find the code corresponding to the brand of your device in the list at the back of this guide.
The brands are listed in alphabetical order.
3. Hold down
and
until the red light under
blinks twice, then release both buttons.
4. Enter the first five-digit code on your device. If you have done it correctly, the
backlight
will blink twice.
NOTE: If the button blinks once and remains lit for a long time, this means the code you have
entered is invalid. Repeat steps 3 and 4 using the same code or another code, if possible.
5. Point the remote control at your device and press
. The device should turn off. If nothing
happens, repeat steps 2 to 5.
6. To program your audio device, repeat steps 2 to 5.
7. When your remote control has been programmed, we strongly recommend that you select
its model and volume control in order to ensure that it works properly (see the
Equipment
Settings
section on page 16).
Your TV code: _________________
Your audio system code: _________________
NOTE
: When you have programmed the remote control to your audio system, you will no
longer be able to adjust the volume on your TV, only on your audio system. However, this
setting can be modified by following the instructions on page 16 (see the
Change How Your
Remote Control is Programmed
section).
